SCOPREGA GE 1800 ROMA Manual De Instrucciones página 11

I N S T R U C T I O N S
7. WARNING! RISK OF EXPLOSION.
Inflate the inflatable unit only complying with the manufacturer's recommendations. Exceeding the
pressure rating could cause the inflator to explode, resulting in personal injury.
8. NEVER LEAVE THE DEVICE UNATTENDED.
Overinflation could result in serious injury and property damage.
9. WARNING! RISK OF UNSAFE OPERATION.
Do not modify or attempt to repair the unit. Do not drill into or make any modifications to the inflator
or its accessories. Any modification to the product will void its warranty.
10. NEVER CARRY THE INFLATOR BY THE FLEXIBLE HOSE OR POWER CABLE.
11. DO NOT OBSTRUCT THE SUCTION PORT
5. INTRODUCTION
The GE 1800 ROMA is a device capable of maintaining the nominal pressure in inflatable items
within preset values (min. 50 mbar, max. 360 mbar), regardless of ambient temperature. The unit
constantly monitors pressure variations within the item and regulates refilling and deflation in case of
overpressure (A.R.S. Automatic Refilling System).
1. The GE 1800 ROMA is a unit that is able to INFLATE and MAINTAIN an inflatable item at a preset
pressure. THIS MEANS THAT THE INFLATABLE ITEM MUST ALWAYS BE CONNECTED TO THE
INFLATOR.
2. THE INFLATOR IS DELIVERED WITH A FACTORY PRE-SET PRESSURE. TO CHANGE THIS SETTING
PLEASE READ THE INSTRUCTIONS CAREFULLY (CHAPTER 8). IN CASE OF DOUBT, PLEASE CONTACT
THE SCOPREGA SERVICE DEPARTMENT.
WARNING
3. THE INFLATOR IS EQUIPPED WITH A THERMAL OVERLOAD CUTOUT THAT INTERRUPTS THE
INFLATING OPERATIONS IN CASE OF MOTOR OVERHEATING. NORMAL OPERATION WILL CONTINUE
AUTOMATICALLY AFTER A 20/40-MINUTE PAUSE.
4. THE INFLATOR IS SUPPLIED WITHOUT HOSES OR FITTINGS. HOSES AND FITTINGS SUITABLE
FOR THIS INFLATOR FOR CONNECTING TO THE MOST COMMON INFLATION VALVES CAN BE
PURCHASED FROM AUTHORISED SCOPREGA CENTRES.
6. TECHNICAL SPECIFICATIONS
1. Power supply
2. MAX. power
3. MAX. pressure
4. MIN. pressure
5. Filling pressure tolerance
6. MAX. flow rate
7. Dimensions
8. Weight
9. Operating temperature range
10. Protection degree
7. HOW TO USE
1. Connect the inflation hose to the inflation port of the GE 1800 ROMA and to the main valve of the
inflatable item.
2. Connect the fitting (circled in red in figure 2) to another valve of the inflatable item using a PU (or
PA) hose with a diameter of 6 mm and a maximum length of 5 m.
THE PRESSURE CONTROL HOSE AND THE 6 MM VALVE ADAPTOR ARE NOT
INCLUDED!
210-240 Vac; 50 Hz or 110-130 Vac, 60 Hz
1800 W
360 mbar (5.2 psi)
50 mbar (0.7 psi)
adjustable from 30 to 70 mbar
2700 l/min
330 x280 x h 350 mm
6.4 kg
-10/40°C
IP 66
11