Publicidad
Idiomas disponibles
Idiomas disponibles
(78)
Haojue DR160/DR160S 99011H2J024H000 V04 ES+EN+FR 2020-1-17
BCAUTION
Do not do frequent power-on self-checking in short
time, otherwise the dashboard may be damaged.
TACHOMETER 1
The tachometer displays the engine's revs, indicating its
revolutions per minute.
BCAUTION
Even if the engine break-in has been completed,
the tachometer's needle must not enter into the
red area. The red area indicates that the engine
has entered in its rotational speed limit. Riding
the motorcycle in this area could break the engine
down.
BATTERY RECHARGE INDICATOR 2 F
The battery recharge indicator "F" flashes to remind
EN
you to turn off power consuming equipment including
headlights to avoid over-discharging of the battery. Should
the indicator keep flashing with no power-consuming
equipment in use, the battery is over-discharged and
should be recharged immediately.
NOTE: Should the indicator keep flashing and the
dashboard fail, there may be an open circuit in the power
cord of the battery, or a blown fuse. Check the circuit
carefully.
TIMER 3
The clock is displayed in 12 hour system, the clock can be
(78)
Haojue DR160/DR160S 99011H2J024H000 V04 ES+EN+FR 2020-1-17
adjusted as follows.
Press the "ADJ" button
mode of adjusting the timer, at this time, the one figure
of the timer will flash. Press the "SEL" button
figure increase, if you hold the "SEL" button
increase continuously. Press the "ADJ" button
figure will flash, use the "SEL" button
adjust all figures, press the "ADJ" button
of adjusting the timer, set the figures of the second to zero,
then continue to count.
SPEEDOMETER 4
The speedometer indicates the riding speed in km per
hour.
TOTAL METER AND TRIP METER 5
The TOTAL meter registers the total distance that the
motorcycle has been ridden. TOTAL meter ranges from
0 to 199999.
The TRIP meter is mainly used to calculate distance of a
short ride, or for fuel consumption calculation. TRIP meter
ranges from 0 to 999.9.
You may shift the TOTAL and the TRIP meter with SEL
button
, and reset the TRIP meter, refer to the "SEL"
button
section for details.
NOTE: When display TOTAL meter, character string
"TOTAL" should be displayed; when display TRIP meter,
character string "TRIP" should be displayed.
NOTE: After the TRIP meter reach to the maximum value,
reset the value to zero automated, then continue work.
13
for two seconds, enter the
, the
, the figure
, the next
to adjust, after
, exit the mode
Publicidad
