Noise Emission / Personal Protective Equipment; Other Dangers; Essential Operator Skills; Putting Into Operation - Heiniger DELTA3 Manual De Instrucciones

2.4.3 Noise emission / Personal protective equipment

Wear ear protectors!
The noise emission when working is typically 77 dB(A). We recommend that ear protectors
should always be worn when working.
Wear protective goggles and gloves!
For your own personal protection, we recommend that you should wear protective goggles
and gloves.
Personal protective equipment is to be provided by the operator.

2.4.4 Other dangers

Should dangers or potential dangers that are not directly related to the clipping of the animals
occur during operation, we would ask you to inform us about these. This also applies to
dangerous technical deficiencies.

2.5 Essential operator skills

The safe operation of the machine only places minimal requirements on the operating
personnel. It is, however, essential that these are observed and complied with.
• The operator must have experience in handling the animals to be sheared.
• The operator has read and understood the operating instructions, or the use of the machine
has been explained to him/her by an expert and the risks involved have been pointed
out.
Children are not permitted to operate the equipment.

3 Putting into operation

3.1 Controls and operating notes

There are dangers inherent in the improper use of electrical equipment, especially stock
breeding equipment! You should therefore always observe the following accident prevention
measures before putting the machine into operation:
• The mains voltage must be the same as that stated on the nameplate. The machine may
only be connected to an AC supply.
• Avoid all contact with the moving clipper blades.
• Even when the machine is switched off, do not handle the area of the clipper blades as
long as the machine is connected to a power source. Always disconnect the power supply
before working on the clipper blade / clipper head.
• Avoid touching a machine that is in contact with liquids. Never clip wet animals. Any
liquid that gets into the machine will lower the electrical insulation. There will then be a
danger of electric shock or a short circuit. Only clean the machine dry, using a brush and
the supplied cleaning brush.
• An electric cable lying loose on the ground for any distance can snag and become a
6 Instruction manual DELTA3