MO-EL MO-FLAG 637M Uso Y Mantenimiento página 9

and cleaning operations. Make sure that the wall where you plan to
install the product is solid and that there are no electrical wires or
water pipes behind the wall.
1. Place the plastic washer (A) on the upper side of the product in
line with the insert on the same side.
2. Place the medium washer (B) over the plastic washer.
3. Place the small washer (C) on top of the medium washer.
4. Set the bracket as shown in the figure (1). Place the large washer
(D) over the bracket.
5. Screw in the M4 screw (supplied) with a Phillips screwdriver.
6. Same procedure on the underside of the product.
7. Fix the product to the wall by inserting 4 screw anchors (not
supplied) in the holes of the brackets (Fig.2).
8. The product can be attached to the ceiling using 2 S-hooks and a
chain (not supplied) in the appropriate holes (E) on the upper side
of the product
9. Insert the adhesive paper: remove the protective film and slide the
paper into the guide (Fig.3).
CLEANING AND CARE
Before cleaning or doing any maintenance on the product,
make sure that the contacts of the bipolar circuit breaker are
open or that the product is unplugged.
A general cleaning of the product is recommended every time
the adhesive paper is replaced. If food is being produced in the
environment, use an appropriate non-volatile and non-contaminating
cleaner. Carry out maintenance operations only after cutting off the
power supply to the product.
For better operation of the product, we recommend replacing
the lamp once a year.
The adhesive paper should be changed at least once a month, more
frequently if the space is full of insects or particularly dirty. If the
adhesive paper gets stuck to the lamp, clean the lamp using a soft
cloth dampened with a non-corrosive cleaner; avoid scratching.
9