MO-EL IRIS Uso Y Mantenimiento página 14

The product is in class I and IP55, wich is the protection rate for
•
the units to be used even outdoor. For keeping the protection rate
of the appliance, the connection of the appliance with the power
supply must be done by means of a minimum IP55 system, as per
the standards HD 384 CENELEC for Europe, or international IEC
60346-7-708 1988.
3. LOCATION
All irradiation heaters are designed to achieve and maintain a certain
thermal comfort to the people who need it both outside and inside. It
is therefore very important to carefully study the area where people
stay and consequently direct the radiation towards them.
The IRIS range of heaters is deliberately designed to be very flexible
in the choice of position.
There are three basic options:
A wall mounting bracket version with a specifically designed
•
fitting for wall attachment . Before drilling the holes for the dow-
els, be sure that the wall is solid and that you are far from water
tubes or electrical wires. For fixing the appliance at the wall, drill
four holes with a 5 mm diameter bit and fix the wall bracket with
the dowels and screws (not supplied)(fig.2). With the two screws
supplied, fix the two brakets attached to the aluminum tube on the
back of the appliance and lock it in the right angle (fig.3).
A chain suspended version. With 2 supplied S-hook, fix the two
•
supports attached to the aluminum tube on the back of the appli-
ance to the last link in the chain. Fix the opposite end of the chain
to the support attached to the wall or where there is another fixing
point. (Fig. 4)
Ensure that the supply cable is well mounted and that it does
not come into contact with the reflector of the heater or that
it does not trail into the heated area.
4. USE
The IRIS range consists of a 1200 W heater and an 1800 W heater.
The essential element of the heater is the halogen filled quartz linear
lamp with a tungsten element. The heater operates at full output al-
14