MO-EL AAREN RECESSED 9011 Uso Y Mantenimiento página 12

USING THE REMOTE CONTROL
For maximum flexibility 9011 is available with dimmer to adjust the
intensity of the heater comfortably by remote control.
Insert into the remote control a 12V A23 battery (not included),
-
matching the polarities.
Connecting the machine.
-
Use the remote control as shown in table.
-
ON Ignition device
STANDBY Shutdown device
LOW Select 1/3 of power: the blue LED lights on
MED Select 2/3 of power: the violet LED lights on
HIGH Select max power: the red LED lights on
After each restart, the product will return to the setting selected
MOUNTING
Make sure that the false ceiling in which you intend to fix the appliance is
solid and that no electric lines or water pipes pass inside it.
1. Lift and remove two panels side by side and disassemble the
support bar between the two. (FIG.1)
2. Connect the product to the mains by opening the connection
box and passing the cable through the appropriate cable gland.
(FIG.2)
3. Lift the product by tilting it to allow it to pass inside the opening
created by removing the panels. (FIG.3)
4. Lay the product on the side support bars of the false ceiling,
taking care that the power cable is not in the way and is not
resting on the product.
5. Once the product has been fixed, it can be secured to the ceiling
using safety chains or tie rods, anchoring them to the holes in
the internal bodywork.
Ensure that the heater turns her rays in the area to be heated.
before it was turned off.
12