Extel VisioSmart Instrucciones De Uso E Instalación página 56

1. Screw the shield to the wall using the screws supplied (suitable for solid walls) or screws suited to the support.
2. Connect the provided power cable to the back of the intercom panel (the red wire in V+ and the black wire in
V-), without turning on the intercom and, as the case may be, the Ethernet cable.
3. Insert a micro SD card if you wish to make recordings.
4. With the provided cable, connect the strike plate or electric lock to the O1/O2 terminals on the back of the
intercom (no polarity requirements to follow).
Important:
The strike plate or electric lock that you install must have a mechanical memory and be energy
efficient, like all EXTEL products.
5. With the provided cable, connect the gate motor to the C1/C2 terminals on the back of the intercom panel (dry
contact with no current that should be connected to the "push button" control of your opening mechanism).
6. Insert the intercom panel into the shield and fasten it using the anti-theft screws provided.
7. Connect the power supply to the mains.
Important:
If modifying the power cord, be sure to comply with the polarity (the red wire of power cable and
the white border of the power unit = (+)).
8. USER MANUAL
A. Pressing the intercom panel button triggers a call or notification on your mobile device. Remember to
authorise calls or notifications in OMGuard HD in your mobile device's settings.
B. Once you have accepted the call, you can see your visitor and respond by pressing the microphone button.
To end the call, press
GB7
or close the application.
CFI EXTEL - VISIOSMART - 09/2017