Publicidad
Idiomas disponibles
Idiomas disponibles
Self Diagnosis and Specifications
Self Diagnosis and Trouble shooting
Status
1.Low water pressure of the unit
Water flow to pressure is too
low during Cleansing/Bidet
2.Low water pressure of water supply
1. Water shut-off valve is turned off
2. Filter net of T-shaped connector is stuck
No water comes out
during Cleansing/Bidet
3. Nozzle tip is stuck
4. External water pressure is low
Water dripping into the
External water pressure is too high
bowl when using the unit
Caution
Specifications
Classification
Model No.
Back Cleansing water flow volume
Front Cleansing water flow volume
Backflow Prevention
Water Supply
Water Pressure Range
Dimensions
Weight
To request service:
1. Please recheck the user's manual.
2. If failure or damage occurs after refering the manual,stop using the product and contact the
retailer or local service center.
Cause
Do not disassemble, repair or modify the unit.
9
Solution
1. Adjust the water pressure volume by the lever.
2. Assure the nozzle tips are clean.
1.Check if the water pressure is above 10 psi.
2. Fully open the shut-off valve
3. Check if there are any kinks on the water supply hose.
Turn on the water shut-off valve
Clean the filter net of T-shaped connector
Take off and clean the nozzle tip
Increase external water pressure.
The maximum water pressure of the unit is 0.8MPa.
Description
8033A65G.020
0.4 - 1.8 L/min
0.4 - 1.8 L/min
Backflow Prevention
Direct from water pipes
Static pressure: 0.14-0.86MPa, Dynamic pressure:above 0.07Mpa
490X405X63mm
2.1 KG
760416-100EN Rev. 1 6/22
Publicidad
