Beta 1438K/PWR Instrucciones página 8

INTRODUCTION
Please read this manual before carrying out any operation. It is compulsory to read this instruction
manual before starting any kind of action. The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this manual are closely adhered to.
We guarantee that this product complies with the technical specifications described in this manual.
The manufacturer shall not be held responsible for any improper uses other than those described
herein. Use protective work gloves, protective footwear, hard hat and safety goggles.
Misuse:
- This product should only be used as described in this documentation; any other use is
considered improper.
- The manufacturer accepts no responsibility for any damage caused by the incorrect or
unreasonable use of the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
WARNINGS
The tool set has been designed to remove and install new clutches DPS6 and 6DCT250; it is meant for
use only with the above-mentioned clutches.
DUAL CLUTCH DISASSEMBLY
Warning: when removing the gearbox, closely adhere to the instructions provided by the
car maker/manufacturer.
- Place the gearbox on a suitable workbench and position it so that the clutch casing bell faces upwards.
- Note the position of the clutch on the cover (see fig. 1).
- Remove the outer snap ring of the clutch disc (see fig. 2) by using a screwdriver.
- Remove the clutch cover.
- To remove the snap ring of the main shaft, push it downwards (see fig. 3).
Fig. 1
Fig. 2
Fig. 3