CONGA 2290 ULTRA T Manual De Instrucciones página 27

ENGLISH
Beeps while the indicator light is steady red:
Beeps Error
01 1 Driving wheel error
02 2 Robot's side brushes
error
03 3 Fan error
02 4 Main brush error
Other possible scenarios
Problem Solution
The robot does not turn on Make sure that the switch is set to the On position.
Make sure the battery is fully charged.
Change the remote control batteries (2 AAA).
Make sure the remote control is within the robot range (16
ft/5 m).
If the problem continues, turn the switch off and restart it.
The remote control does Change the remote control batteries (2 AAA).
not work. Make sure the robot is on and the battery is fully charged.
The device suddenly stops Check if the robot is trapped or stuck with any obstacle.
working. Check the battery level.
If the problem continues, turn the switch off, wait for 2
seconds and restart it.
The programming function Make sure the power switch in the lower part of the robot
does not work is on.
Make sure the time (AM/PM) and time settings are correctly
set.
Check if the robot's battery is too low to turn on.
Suction power level is very Check if there are obstructions blocking the air inlet.
low Empty the dust tank.
Clean the filters with a vacuum cleaner or a cleaning brush.
Check if the filters are wet.
Dry the filters in a natural way before using them.
52 CONGA 2290 ULTRA T
Solution
Check if the driving wheel is blocked.
Check if the side brushes are blocked and clean
them.
Clean the dust or objects that may be blocking
the air inlet channel.
Check if the main brush is tangled or blocked
and clean it.
The robot does not charge. Check if the charging base indicators are on. If they are not,
contact the official Technical Support Service of Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the charging base.
Otherwise, contact the official Technical Support Service of
Cecotec.
The robot does not return to Remove the objects 1 metre on the left and right, and 2
the charging base metres in front of the charging base.
The robot will return to the charging base faster when it
is near it. When it is far, it will take more time to identify it.
Clean the charging terminals.
The main brush does not Clean the main brush.
spin. Check if the main brush is installed correctly.
The robot movements and Carefully clean the sensors with a dry cloth.
route are unusual. Restart the robot. To do so, turn it off and on.
6. TECHNICAL SPECIFICATIONS
Product: Conga 2290 Ultra T
Product reference: 05734
Voltage: 19 V DC
Output current: 0.6 A
Power: 40 W
Battery: 14.4 V DC, 2600 mAh Li-Ion
100-240 V AC ~, 50/60 Hz
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE) specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimise the recovery
and recycling of the materials they contain and reduce the impact on
human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation to
dispose of the appliance correctly. Consumers must contact their local authorities or retailer
for information concerning the correct disposal of old appliances and/or their batteries.
ENGLISH
CONGA 2290 ULTRA T 53