CONGA 2290 ULTRA T Manual De Instrucciones página 28

ENGLISH
8. TECHNICAL SUPPORT AND WARRANTY
This product is under warranty for 2 years from the date of purchase, as long as the proof
of purchase is submitted, the product is in perfect physical condition, and it has been given
proper use, as explained in this instruction manual.
The warranty will not cover the following situations:
- The product has been used for purposes other than those intended for it, misused,
beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any
other fault attributable to the customer.
- The product has been disassembled, modified, or repaired by persons, not authorised by
the Cecotec official Technical Support Service.
- Faults deriving from the normal wear and tear of its parts, due to use.
The warranty service covers every manufacturing defect of your appliance for 2 years, based on
current legislation, except consumable parts. In the event of misuse, the warranty will not apply.
If at any moment you detect any problem with your product or have any doubt, do not
hesitate to contact Cecotec official Technical Support Service at +34 963 210 728.
COPYRIGHT
The intellectual property rights over the texts, designs, photographs and illustrations in
this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of
this publication may not, in whole or in part, be reproduced, stored in a retrieval system,
transmitted or distributed by any means (electronic, mechanical, photocopying, recording or
similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.
54 CONGA 2290 ULTRA T
1. PIÈCES ET COMPOSANTS
Img. 1
Indicateur du Wi-Fi
Bouton de connexion/fonctionnement
Bouton Retour à la base
Bouton Retour à la base
Lorsque vous appuyez sur ce bouton, que ce soit sur celui du robot ou sur celui de la
télécommande, le robot retourne automatiquement à sa base de charge.
Témoin lumineux
- En charge : lumière orange clignotante
- Charge complète : lumière bleue
- Mode Standby : lumière bleue
- Erreur : lumière rouge fixe/clignotante
- Batterie faible : lumière orange
- En cours de nettoyage : lumière bleue
- Mise en veille : lumière éteinte
Bouton de connexion/fonctionnement
- Maintenez appuyé ce bouton quelques secondes pour allumer ou éteindre le robot.
- Appuyez sur ce même bouton pour commencer le nettoyage.
Img. 2
1. Capteur antichoc
Img. 3
1. Capteurs antichute
2. Roues motrices
3. Témoin d'alimentation
4. Bornes de charge
5. Roues omnidirectionnelles
6. Brosses latérales
7. Batterie
8. Réservoir de saleté
9. Brosse centrale
Img. 4
Base de charge
FRANÇAIS
CONGA 2290 ULTRA T 55