Publicidad
Idiomas disponibles
Idiomas disponibles
Start the brush cutter only in accordance with the instructions.
– Do not use any other methods for starting the engine.
– Use the brush cutter and the tools only for such applications as specified.
– Only start the brush cutter engine, after the entire assembly is done. Operation of the device
is only permitted after all the appropriate accessories are attached.
– Before starting make sure that the cutting tool has no contact with hard objects such as
branches, stones etc. as the cutting tool will revolve when starting.
– The engine is to be switched off immediately in case of any engine problems.
– Should the cutting tool hit stones or other hard objects, immediately switch off the engine and
inspect the cutting tool.
– Inspect the cutting tool at short regular intervals for damage (detection of hairline cracks by
means of tapping-noise test).
– Operate the brush cutter only with the shoulder strap attached which is to be suitably
adjusted before putting the brush cutter into operation. It is essential to adjust the shoulder
strap according to the user's size to prevent fatigue occurring during use. Never hold the cutter
with one hand during use.
– During operation always hold the brush cutter with both hands. Always ensure a safe footing.
– Operate the brush cutter in such a manner as to avoid inhalation of exhaust gas. Never run
the engine in enclosed rooms (risk of gas poisoning). Carbon monoxide is an odorless gas.
– Switch off the engine when resting and when leaving the brush cutter unattended, and place
it in a safe location to prevent danger to others or damage to the machine.
– Never put the hot brush cutter onto dry grass or onto any combustible materials.
– The cutting tool has to be equipped with it's appropriate guard. Never run the cutter without
this guard.
– All protective installations and guards supplied with the machine must be used during
operation.
– Never operate the engine with faulty exhaust muffler.
– Shut off the engine during transport.
– When transporting the equipment, always attach the cover to the cutting blade.
– Ensure safe position of the brush cutter during car transportation to avoid fuel leakage.
– When transporting the brush cutter, ensure that the fuel tank is completely empty.
– When unloading the Brush Cutter from the truck, never drop the Engine to the ground or this may severely damage the fuel tank.
– Except in case of emergency, never drop or cast the Brush Cutter to the ground or this may severely damage the Brush Cutter.
– Remember to lift the entire equipment from the ground when moving the equipment. Dragging the fuel tank is highly dangerous and will
cause damage and leakage of fuel, possibly causing fire.
– If the equipment gets heavy impact or fall, check the condition before continuing work. Check
the fuel system for fuel leakage and the controls and safety devices for malfunction. If there is
any damage or doubt, ask our authorized service center for the inspection and repair.
Refueling
– Shut off the engine during refuelling, keep away from open flames and do not smoke.
– Avoid skin contact with mineral oil products. Do not inhale fuel vapor. Always wear protective
gloves during refuelling. Change and clean protective clothing at regular intervals.
– Take care not to spill either fuel or oil in order to prevent soil contamination (environmental
protection). Clean the brush cutter immediately after fuel has been spilt.
– Avoid any fuel contact with your clothing. Change your clothing instantly if fuel has been spilt
on it (to prevent clothing catching fire).
4
Publicidad
