Publicidad
Idiomas disponibles
Idiomas disponibles
reliable operation with a minimum emission of exhaust gases is guaranteed. It is absolutely essential to observe a mixture ratio of 30:1
(specified 2-stroke engine oil), as otherwise reliable function of the brush cutter cannot be guaranteed.
The correct mixture ratio:
Mix 30 parts gasoline with 1 part specified 2-stroke engine oil (see table on right).
NOTE: For preparing the fuel-oil mixture first mix the entire oil quantity with half of the fuel required, then add the remaining fuel. Thoroughly
shake the mixture before filling it into the brush cutter tank. It is not wise to add more engine oil than specified to ensure safe operation. This
will only result in a higher production of combustion residues which will pollute the environment and clog the exhaust channel in the cylinder
as well as the muffler. In addition, the fuel consumption will rise and the performance will decrease.
The engine must be switched off.
– Thoroughly clean the area around the fuel filler cap, to prevent dirt from getting into the fuel tank.
– Unscrew the fuel filler cap and fill the tank with fuel.
– Tightly screw on the fuel filler cap.
– Clean screw fuel filler cap and tank after refueling.
Storage of Fuel
Fuel cannot be stored for an unlimited period of time. Purchase only the quantity
required for a 4 week operating period. Only use approved fuel storage containers.
CORRECT HANDLING OF MACHINE
Attachment of shoulder strap
– Wear shoulder strap across the chest. Keep machine at your right.
– Adjust the strap length so that the cutter blade will be kept parallel with the ground.
Detachment
–Put on the full harness (1). Adjust the length of the strap so that the carabiner (2) is about a
hand's width below your right hip. Attach the carabiner to the machine's perforated rail (3) – see
"Attaching Machine to Harness". Find the right attachment point for the cutting attachment you
are using
–In case of emergency, remove the emergency detachment lever (1) by
pulling strongly with a finger. The machine sill detach from body.
Be extremely careful to maintain control of the machine at this time. Do not
allow the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious bodily injury or DEATH.
Balancing the Machine
The machine will balance differently depending on the cutting attachment mounted. Let the machine swing on the harness until it stops
moving change the connection point if necessary.
10
Publicidad
