Haverland TAC-0923WC Manual De Instalacion Y Uso página 39

3. OPERATION UK
(FULL TANK as mentioned in SELF-DIAGNOSE). This indicates that the water condensation
needs to be drained using the following procedures:
Manual Draining (fig.24)
1. Unplug the unit from power source.
2. Place a pan (not supply) under the lower drain plug. See diagram.
3. Remove the lower drain plug.
4. Water will drain out and collect in the pan.
5. After the water is drained, replace the lower drain plug firmly.
6.Turn on the unit.
Continuous Draining (fig.25)
1. Unplug the unit from the power source.
2. Remove the drain plug. While doing this operation some residual water may spill so please have a
pan not supply) to collect the water.
3. Connect the drain hose (1/2" or 12.7mm, not supply ). See diagram.
4. The water can be continuously drained through the hose into a floor drain or bucket.
5. Turn on the unit.
NOTE
Please be sure that the height of and section of the drain hose should not be higher than that of the
drain outlet, or the water tank may not be drained. (fig. 26 and fig. 27)
UK
Middle drainage
When unit running in Dry mode, you can choose the way below to drainage:
TAC-23WC
39