Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Cycle Options
H
Deep Fill
Select the Deep Fill feature for loads where extra water is needed.
The Deep Fill feature is recommended for special case
loads only, not for typical use.
Press the Deep Fill button once before starting the cycle to add an incremental amount of water to the wash load. Holding the
Deep Fill button for 3 seconds will provide the deepest fill level possible; this will increase cycle time due to the additional time it
takes to fill the washer.
To cancel the option if desired, press the Deep Fill button again.
NOTE: The Deep Fill button can also be pressed after the washer has completed filling and is in the wash phase if additional
water is desired. To stop the extra fill, press the Deep Fill button again and the water will stop.
Warm Rinse
Provides a warm rinse to your wash load. Note that rinsing operations may be different with this operation selected in order to
effectively apply the warm rinse water to your load.
Auto Soak
This option begins with a brief agitation, soaks for a specified period of time, then moves through the rest of the cycle
automatically. Repeated pressing of the Soak button will scroll through 15 minute, 30 minute, 1 hour and 2 hour selections and
then return back to 0 soak minutes.
Deep Rinse
Set this option to provide a deep rinse or when using fabric softener. It may change other settings (e.g. Spin may go to a higher
setting) to maximize performance.
Delay Wash/Delay
When the Delay Wash button is repeatedly pressed, the delay time is set from 1 (01H) to 9 (09H) hours and back to clear (00H)
hours. If you press and hold the Delay Wash button for 3 seconds, it will immediately reset.
Extra Rinse
When you use extra detergent or bleach to clean heavily soiled clothes, use the Extra Rinse option to better remove additional
residues. NOTE: This option is not allowed for some cycles.
Eco Cold (on some models)
Select the Eco Cold feature when energy savings are desired. Eco Cold saves energy by using less water heater energy for cold
water vs. normal default settings.
Eco Cold will change the default settings to Auto Fill, Tap Cold water temperature, Max Spin, and normal rinse.
To cancel the option, press the Eco Cold button again.
NOTE: The Eco Cold feature will be deselected if the water temperature is changed from Tap Cold or the spin from Max Spin.
Soaking Rinse (on some models)
Select the Soaking Rinse feature when laundry sanitizer is used. The Soaking Rinse feature is recommended for special case
loads only, not for typical use.
Press and hold the Extra Rinse button for at least 3 seconds to enable Soaking Rinse. An additional chime will occur and the
cycle time will increase due to additional soaking time to activate the laundry sanitizer.
To cancel the option, press the Extra Rinse button again.
NOTE: In order to fit the required volume of laundry sanitizer, the unit has been equipped with a dispenser drawer and a dispenser
cup in the agitator. First fill the dispenser drawer to its max volume and put any remaining liquid into the dispenser cup.
14
49-3000346 Rev 0
Publicidad
