Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Water Level (on some models)
D
Add
detergent to the bottom of the basket and fabric softener to the dispenser (on some models) prior to loading clothes.
Loosely load items in the washer basket. Overloading may negatively impact wash performance. Adjust the load size
accordingly. Make the load selection:
Auto (on some models)
– For convenience, best performance and optimal efficiency, select Auto for models so equipped. This selection automatically provides
the correct amount of water suited to the size and type of load placed in the unit. Lid will be locked for the duration of the load sensing
process, which includes a brief spin period and a portion of the water fill.
– If you prefer to manually select the water level, select Low through Max. While Auto is best for most loads and general washing, you
may want to manually select the load size for specialty items such as bulky, lightweight comforters or pillows, where you want to ensure
a larger water level is applied. Manual load size selections should be made for wet items placed in the washer, such as soaked towels
or garments.
– The washer will not fill with water when Auto is selected if the lid is opened. When the lid is closed the machine is able to
begin filling with water in order to sense the load size.
NOTE: This is a high-efficiency washing machine. This system requires less water while providing effective cleaning action. You may
notice that the water level is lower than on your previous washer. This is normal.
Consumer Help Indicator
Your washer is equipped with Consumer Help Indicator (CHI). CHI is our way to communicate a simple remedy for some situations
that you can perform without the need to call for service. The chart below describes the helpful messages you may notice scrolling
on your display when you return to start another load. These messages will provide simple remedies you can quickly perform.
Spin light blinking
If an out-of-balance condition is detected by the washer, the Spin light will blink during the remaining portion
of the cycle and will stay illuminated for a short time after cycle completion. When this occurs, the washer
is taking actions to correct the out-of-balance condition and complete the cycle normally. In some cases,
the washer may not be able to balance the load and spin up to full speed. If you notice the load is more wet than
normal at the end of the cycle, redistribute the load evenly in the wash basket and run a Drain & Spin cycle.
"H2O SUPPLY"
Check your house water supply. Did you forget to turn on one or both supply valves after installation or
(Water not
coming back from vacation? As soon as the message starts to scroll, the washer will initiate a 4 minute lock-
entering washer)
out period. The washer controls won't respond/change during this time. After the 4 minutes, you can begin
your cycle again. If you try to bypass the lock-out period by unplugging the washer, the 4 minute timer will
start over again.
"CAnCELEd"
"CAnCELEd" may scroll on the display if the machine was paused for longer than 24 hours or if the machine
has stopped itself before the cycle completed due to certain errors. As soon as the message starts to scroll,
the washer will initiate a 4 minute lock-out period. The washer controls won't respond/change during this time.
After the 4 minute period, you can begin your cycle again. If you try to bypass the lock-out period by unplugging
the washer, the 4 minute timer will start over again. If the problem persists, call GE Appliances at 800.
GE.CARES (800.432.2737) for service.
"Lid"
"Lid" will be shown on display if 3 cycles have been started without opening the lid. The washer will not
start another cycle until the lid is opened. Try opening, then closing the lid and starting a new cycle. If the
problem persists, call GE Appliances at 800.GE.CARES (800.432.2737) for service.
49-3000346 Rev 0
9
Publicidad
