Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Loop handle version
1. Loop handle
2. Screw M5×35
3. Loop handle bracket
1. Shield
1.
Bracket
2.
Bolt
3.
Button
WARNING
4. Nut
5. To engine
2. Bolt
4.
Shield (for nylon line
cutting head)
5.
Shield (for metal
blade)
Before you start
Before you start
Loop handle assembly
Assemble loop handle and bracket to drive shaft assembly.
Position handle in comfortable operating position and tighten
screws (M5×35).
Install the handle so that it does not hide any of the
safety decals.
Installation of shield
Fit shield to mounting portion of angle transmission and tighten 4
bolts.
Method to change shield
There are two types of shields: namely the one used exclusively
for nylon line cutting head and the other one used exclusively for
metal blade. When metal blade is used, use the shield for metal
blade.
Fully loosen the bolt on the right side of the bracket to slide the
shield. The bolt itself cannot be removed from the bracket. Push-
ing the button, slide the shield to the left and remove it. Put shield
of other type into groove and slide it to the right until it stops. Be
sure to tighten the bolt.
17
CAUTION
Publicidad
