Publicidad
Idiomas disponibles
Idiomas disponibles
1. Wire fixing clips
2. Shaft tube
1. Wire end
2. Nuts
1. Shield
1.
Bracket
2.
Bolt
3.
Button
3. Throttle wire
3. Carburettor
2. Bolt
4.
Shield (for metal
blade)
5.
Shield (for nylon line
cutting head)
Before you start
To eliminate loosening of throttle wire fix it to shaft tube (2 places)
and to right hand U-handle (1 place) with wire fixing clips.
After assembly, adjust the play of wire end on carburettor
side to 1 mm - 2 mm.
Installation of shield
Fit shield to mounting portion of angle transmission and tighten 4
bolts.
Method to change shield
There are two types of shields: namely the one used exclusively
for nylon line cutting head and the other one used exclusively for
metal blade. When using nylon line cutting head, use the shield
for nylon line cutting head.
Fully loosen the bolt on the right side of the bracket to slide the
shield. The bolt itself cannot be removed from the bracket. Push-
ing the button, slide the shield to the left and remove it. Put shield
of other type into groove and slide it to the right until it stops. Be
sure to tighten the bolt.
21
CAUTION
Publicidad
