Glacier bay 873X-0804 Guía De Uso Y Mantenimiento página 14

Installation (continued)
12
Checking for leaks
□
Turn the handle (F) to the full on mixed position.
□
When the valve body (D) is turned on, water
normally ows through the tub spout (J). To
activate the shower, turn the valve on and pull
the knob (1) up. Hold the knob (1) until the water
ows continuously from the shower arm (B).
Check for leaks.
□
Shut off the water at the faucet and supply lines.
NOTE: When the pattern of the water ow switches to
the shower from the tub spout, some low leakage from the
tub spout is a normal occurrence.
1
J
13
Installing the shower head
□
Attach the shower head (C) to the shower arm
(B). Hand-tighten only.
NOTE: Do not use the thread sealant tape and do not use
wrench to tighten shower head.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
UP
FOR
SHOWER
B
F
J
B
C
14
D