Husqvarna 360BT Manual De Usuario página 14

The engine is not possible to start
Check Possible
cause
Stop button. Stop position
Starter pawl/s. Blocked or
worn starter
pawl/s.
Fuel tank. Incorrect fuel
type.
Carburetor. Adjustment of
the idle speed.
Spark (no Spark plug
spark). dirty or wet.
Electrode gap
on the spark
plug is incor-
rect.
Spark plug is
loose.
There is un-
Spark plug.
wanted mate-
rial on the
spark plug
electrodes.
Engine starts but stops again
Check Possible
cause
Fuel tank. Incorrect fuel
type.
Carburetor. Engine will not
operate cor-
rectly at idle
speed.
Air filter. Clogged air fil-
ter.
14
Troubleshooting
Solution
Set the stop switch to the start position.
Adjust or replace the starter pawl/s.
Clean around the starter pawl/s.
Speak to an approved servicing dealer.
Drain the fuel tank and use correct fuel.
Adjust the idle speed with the idle adjustment screw.
Make sure that the spark plug is dry and clean.
Clean the spark plug. Make sure that the electrode gap is correct. Make
sure that the spark plug is installed with a suppressor.
Refer to technical data for the correct electrode gap.
Tighten the spark plug.
Make sure that the fuel mixture is correct.
Make sure that the air filter is clean.
Solution
Drain it and use the correct fuel.
Speak to your servicing dealer.
Clean the air filter.
1967 - 001 - 20.01.2023