Rohde ST 410 Instrucciones De Uso página 62

8. Instructions for use
8.1. Firing
8.1.1. General operation
The firing process starts by pressing the
 The firing process can be ended at any time by pressing the
indicator go out.
 The firing process can be restarted by pressing the
from the beginning.
 After a restart, you can use the program advance function (see Section 8.1.4.) to skip the individual steps in the
program until you are back at the correct segment.
Note 1:
j
• Press the key to start the firing process - it is recommended that you first check the program numbers and
g
values with the
• It is also a good idea to have a written record of the contents of the firing programs kept and displayed near the
kiln especially if there is more than one user of the kiln.
Note 2:
• Note: during ramping the controller will perform either controlled heating or controlled cooling – as indicated on
the graphical display.
• During soaking the controller display alternates every 15 seconds between kiln temperature and soak period
remaining.
• At the end of each segment, the segment number indicator is incremented.
8.1.2. Operation using the
j
• If the key is pressed during firing, it will be halted (not paused).
j
• Pressing the key again will restart the firing from the beginning.
• The controller will look at the current kiln temperature and if this is greater than the required soak temperature
then it will automatically cool from the current temperature to the soak temperature.
• Since this process may not be desired, the
emergency.
• The program can be paused, or program data can be changed while the controller is firing. This procedure is
preferable to using the
8.1.3. Program delay
The program delay or program time delay can be used to delay the start of the firing program to a specific point in time.
 The program delay can be entered or changed immediately after the start of the respective program.
 Immediately after pressing the
starts can be set with the
j
key and is indicated by the "Program running" indicator for the duration.
key.
j
j
j
key.
j
key, "00.00" appears in the main display. The waiting time before the firing
d f
and keys.
j
key again which makes the "Program running"
j
key. When you restart, the firing program starts again
key should only be used to abort the firing process in an
60 / 291 - EN -