Rohde ST 410 Instrucciones De Uso página 73

10.2.5. Establishing connection manually with a wireless router (ST 411 only)
Process to manually connect an ST 411 control unit to a wireless network using a computer, tablet or
smartphone:
Step Description of the process
1 Switch the control unit off.
f
Press the key and switch on the
2
control unit.
Hold down the
3
in the main display.
f
4
Release the
Using a computer, tablet or smartphone,
manually search for a wireless network
5
(Wi-Fi) or access point.
A wireless network named "Controller"
6
should appear.
Connect the device to the wireless
7
network called "Controller".
Open the web browser on your computer,
8
tablet or smartphone.
Enter "192.168.100.1" in the address bar
9
and go to this address.
A list of available wireless routers is now
10
displayed in the "Wi-Fi Connection" tab.
The appropriate wireless router should
11
now appear as available in this list.
Select the wireless router in the web
12
interface and enter the access data for it.
Confirm with Save/OK and close the web
13
browser.
The controller now automatically
disconnects from the computer, tablet or
14
smartphone because a new connection to
the wireless router has been established.
Switch off the controller and switch it on
15
again immediately.
f
key until "AP" appears
key.
Remark
f
Hold down the key while switching on.
1)
"AP" stands for Access Point.
2)
The control unit creates its own wireless network.
3)
The wireless network via the access point is limited in time
and is closed each time the controller is switched off.
 The computer, tablet and smartphone need to activate
Wi-Fi and scan for new devices.
 Available networks can be searched for on the computer,
tablet or smartphone in the system settings.
 The control unit and the computer, tablet or smartphone
must be in the immediate vicinity.
Ignore the following warnings from your computer, tablet or
smartphone:
­ The internet is not available.
­ This wireless network has no internet access. Connect
anyway.
­ Unsecured network
­ The process of connecting to the Wi-Fi may take a while.
­ Similar warnings may vary depending on the device used.
Executable with all common web browsers.
This so-called "web interface", which is now displayed in the
web browser, consists of 2 tabs, but only the displayed "Wi-Fi
Connection" tab is important for establishing the connection.
The web interface scans for available wireless networks in the
area and displays them in a list.
You should find the access data in the documents attached
to the wireless router.
A successful connection to the wireless router is displayed.
The controller now permanently sets up the wireless network
with the router.
If this was not successful, repeat the steps, starting with

step 1, try the connecting as described in Section
10.2.4.
The controller is now permanently connected to the Wi-Fi
router that has been set up.
71 / 291 - EN -