Ryobi PCL445 Manual Del Operador página 7

PRODUCT SPECIFICATIONS
Grinding Wheel Capacity .......................................4-1/2 in.
Motor ................................................................. 18 Volt DC
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
WARNING:
Do not use this product if any parts on the includes sec-
tion are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
FEATURES
Rated Speed .......................................... 9,000 /min. (RPM)
Spindle Thread ............................................. 5/8 x 11 UNC
ASSEMBLY
INSTALLING/REMOVING WHEEL GUARD
See Figure 1, page 13.
To install:
 Unlock the guard clasp by pulling the clasp out, away
from the grinder.
 Place the guard on the shoulder of the bearing cap by
aligning index dots on guard and bearing cap. Press down
on guard until it is fully seated.
 Rotate the guard to its correct position. Refer to
Positioning the Wheel Guard in Operations.
NOTE: Be sure the raised ridge on the guard is seated in
the groove on the bearing cap.
 Lock the guard clasp by pushing the clasp in.
To remove:
 Remove the disc flange, grinding or cutting wheel, and
flange nut.
 Unlock the guard clasp by pulling the clasp out.
 Rotate guard until dots align.
 Remove the guard.
INSTALLING GRINDING WHEEL
See Figure 1, page 13.
DANGER:
Use ONLY Type 27 depressed center grinding wheels
(such as the one provided with this product). Type 1
straight or cut-off wheels should not be used without
the proper guard. Use for any other purpose is not rec-
ommended and creates a hazard, which will result in
serious injury.
TYPE 27 − OK TO USE
NOTE: This tool can be used with a Type 1 straight or cut-
off wheel if the accessory wheel guard insert is purchased
separately as described in the Operation section later in
the manual.
Look for the accessory wheel guard (p/n 204772004) online
or call 1-800-525-2579.
7 — English
TYPE 1 − DO NOT USE