Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING PROCESS:
GAS CONNECTION:
This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.
This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and
natural gas must only be undertaken by a qualified person.
It is the law that all gas appliances are installed by competent persons in accordance with
the current edition of Gas Safety Installation and Use Regulations.
It is in your interest and that of safety to ensure compliance with the law.
Remove the pan supports, the burner lid and
flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the ignition devices and flame
supervision devices are not damaged in this
operation.
Apply the sponge provided around the edge of
the appliance. The thickness of the sponge is
3 mm and the width is 10 mm.
Do not leave a gap in the sealing agent or
overlap the thickness.
Do not use a silicone sealant to seal the
appliance against the aperture. This will ae it
difficult to remove from the aperture in future,
particularly if needs to be serviced.
Place the bracket (B) over the holes that match
the size of the screw. There are one set of
screws holes in each corner of the hob.
Slightly tighten a screw (C) through the bracket
(B) so that the bracket is attached to the hob,
but so that you can still adjust the position.
Carefully turn the hob back over and then
gently lower it into the aperture hole that you
have cut out.
On the underneath of the hob, adjust the
brackets into a position that is suitable for your
worktop. Then fully tighten the screws (C) to
secure the hob into position.
Publicidad
