easy to operate
BUTTON
:
LIGHT
BUTTON 0:
OFF
BUTTON 1:
SPEED I
BUTTON 2:
SPEED II
BUTTON 3:
SPEED III
AUTOMATIC STOP TIMER - 15 minutes (*)
BUTTON T:
• The appliance has the Power Boost speed function: press
it will be activated for 10 minutes after which it will return to the previously set speed. When
the function is active the LED flashes. To interrupt it before the 10 minutes have expired press
BUTTON 3
again.
• By pressing
BUTTON T
tion is activated. This function switches the appliance on for ten minutes every hour at the
first speed. As soon as this function is activated the motor starts up at the first speed for ten
minutes. During this time
After ten minutes the motor switches off and the LED of
a fixed light until the motor starts up again at the first speed after fifty minutes and
T
BUTTON 1
and
By pressing any key for the exclusion of the hood light the hood will return immediately to its
normal functioning (e.g. if
the motor moves to the 2nd speed straight away. By pressing the
deactivated).
(*) The "automatic stop timer" delays stopping of the hood, which will continue functioning for
15 minutes at the operating speed set at the time this function is activated.
• Active carbon/grease filter saturation:
- When button
flashes at a frequency of 2 seconds, the grease filters must be cleaned.
- When button
flashes at a frequency of 0.5 seconds, the carbon filters must be replaced.
After the clean filter has been replaced, the electronic memory must be reset by pressing
button
for approximately 5 seconds, until the light on the button stops flashing.
for two seconds (with the hood switched off) the "clean air" func-
BUTTON T
start to flash again for ten minutes and so on.
BUTTON 2
Your XO range hood is controlled by these
electronic push buttons which illuminate when
activated.
BUTTON 1
and
must flash at the same time.
BUTTON T
is pressed the "clean air" function is deactivated and
- 21 -
BUTTON 3
for two seconds and
remains switched on with
BUTTON 0
the function is
BUTTON