Publicidad
Idiomas disponibles
Idiomas disponibles
MagicSpeed Accessory
To establish and test the electrical connection, the following tools are
required:
Diode test lamp (fig. 1 9, page 3) or voltmeter (fig. 1 10, page 3)
Insulating tape (fig. 1 12, page 3)
Sealant
Cable bushing sleeves (optional)
To fasten the module and the cables, you may need additional screws and
cable binders.
6.2
Mounting the control panel
Note
I
When selecting the installation location, observe the following
instructions:
Make sure that, when using the control panel, the driver:
– Does not have to reach through the steering wheel
– Does not have to alter the seat position
Make sure that the installation location is not within the possible head
impact or airbag region of the driver or passenger.
Make sure the cables are of the correct length.
Note
I
Also observe the assembly instructions provided with the speed
regulator.
➤ Select a suitable installation location (fig. 6, page 4).
➤ Clean the position where the control panel is to be mounted.
➤ Fasten the control panel using double-sided tape.
Caution
a
Make sure that the connection cable from the control panel does
not make contact with moving parts.
➤ Lay the connection cable to the electronic module.
Installing MagicSpeed
29
Publicidad
