Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting the electrical power to MagicSpeed
7
Connecting the electrical power to
MagicSpeed
7.1
General notes on laying cables
Note
I
As far as possible, use original ducts for laying the cables, or other
suitable options, such as panelling edges, ventilation grilles or
dummy plugs. If no openings are available, you must drill holes for
the cables. Check beforehand that there is sufficient space on the
other side for the drill head to come out.
Note
I
Cables and connections that are not properly installed will cause
malfunctions or damage to components. Correct installation of
cables and connections ensures lasting and trouble-free operation
of the retrofitted components.
Therefore, please observe the following instructions:
To prevent damage to the cables, when laying them, ensure that they are
far enough away from hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.).
Wrap insulating tape around every connection on the cable (even inside
the vehicle).
When laying electric connections (fig. 3, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection
Protect every hole you drill against water penetration, e.g. by using a
cable with a sealant and by spraying the cable and the the cable sleeve
with sealant.
30
MagicSpeed Accessory
Publicidad
