switch on.
• Let the device run (max. 2 minutes) until the water
exits the trigger gun without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
OPERATION
ATTENTION
Dry running of more than 2 minutes leads to
damage of the high-pressure pump. If the appliance
does not build up pressure within 2 minutes, switch
the appliance off and proceed in accordance with
the instructions in Chapter "Troubleshooting"
HIGH PRESSURE WASHER OPERATION
CAUTION
Keep a distance of at least 30 cm when using the jet
for cleaning painted surfaces to avoid damage.
CAUTION
Make sure the on/off switch is set to "OFF/O" and
insert the plug into a properly installed socket.
ATTENTION
• The washer must be used on a secure and stable
surface in a standing, upright position
Connect the product to power and water supply as
described.
• Open the water supply
• Hold the spray gun with both hands.
• Direct the nozzle of the chosen accessory away
from you towards the surface to be cleaned.
• Unlock the trigger and press it until a constant
amount of water flows through the nozzle, to allow
air trapped in the hose to escape.
• Release the trigger.
• Turn on the switch "PW(I)"
• Hold the spray gun with both hands. Direct the
water jet to the object to be cleaned and press the
trigger.
Release the lever of the trigger gun; the device
will switch off again and stop the water jet. High
pressure remains in the system.
WARNING! Beware of kickback when pressing the
trigger!
OPERATION WITH DETERGENT
Detergent can only be added when the device is
operated in low pressure mode.
DANGER:
When using detergents, the material data safety
sheet issued by the detergent manufacturer must
be adhered, especially the instructions regarding
personal protective equipment.
Remove the cap of the clean detergent bottle.
Gently pull the onboard detergent tank out of its
storage position.
Fill the tank with detergent designed specifically for
use with pressure washers.
Push the detergent bottle with the opening pointing
downwards into the connection for the hose clean
detergent.
RECOMMENDED CLEANING METHOD
• Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
• Spray off loosened dirt with the high pressure
Met.