Vacuum Cleaner Operation; Interrupting Operation - URSUS TROTTER UT-HIDROXPERTEN Manual De Usuario

AFTER OPERATION WITH DETERGENT
• Remove the hose clean detergent bottle from the
intake and close it with the lid.
• For storage, put the detergent bottle into the
retainer with the cap pointing up.

VACUUM CLEANER OPERATION

CAUTION
Make sure the on/off switch is set to "OFF(O)" and
insert the plug into a properly installed socket.
Adjust air flow
Open the air flow block , suck power will come
down. If close the block , suck power will max.
power.
Turn on the switch "VAC(II)", then can use it to
clean.

INTERRUPTING OPERATION

• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Put the trigger gun with the spray lance into the
parking position.
• During longer breaks(more than 5 minutes), also
turn the appliance off using the power switch.
FINISH OPERATION
• Release the lever of the trigger gun.
• Turn off the appliance switch pre
• Disconnect the mains plug from the socket.
Only separate the high-pressure hose from the
trigger gun or the device when there is no pressure
in the system.
TURN OFF TAP
• Pressure the lever of the trigger gun to release
any remaining pressure in the system.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
ATTENTION
• When disconnecting the supply or high pressure
hose, warm water may leak from the connection
after operation.
• Detach the appliance from the water supply.
TRANSPORTATION
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
WHEN TRANSPORTING BY HAND
• Switch the product off and disconnect it from the
water and power supply.
• Pull out the transport handle until it audibly
snaps into place. Attach transportation guards, if
applicable.
• Pull the appliance by its transport handle.
WHEN TRANSPORTING IN VEHICLES
• Prior to horizontal transport: close the cap of
clean detergent bottle.
• Tilt the product towards you until it balances
on the wheels. Then move it by its transportation
handle.
• Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
• Secure the appliance against shifting and tipping
over.
STORAGE
CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing
it.
STORING THE APPLIANCE
• Park the machine on an even surface.
• Detach spray lance from the trigger gun.
• Push the disconnect button on the trigger gun and
pull the high-pressure hose out of the trigger gun.
• Place the trigger gun into the storage for the
trigger gun.
• Put both spray lances into the storage for the
spray lance.
• Dirt grinder spray lance: Nozzle towards the
bottom.
• Coil the high-pressure hose and hang it over the
hose storage.
• Store the mains connection in the accessory
compartment.
• Prior to extended storage periods, as during the
winter, also observe the instructions in the care
section.
• Always store the pressure cleaner, parts, and
accessories in a place that is inaccessible to
children. The ideal storage temperature is between
10 °C and 30 °C. Store the power washer indoors to