Publicidad
Idiomas disponibles
Idiomas disponibles
IM WFCH2 V40 P :WFCH1_inst 8/13/09 1:46 PM Page 6
STEP 5
Hang the Filter System Head
1
lign the System Head
on the pipes so that the inlet and outlet are in the correct locations. The "in" port on the Filter
System should be facing the incoming water supply.
2
llow the System Head to temporarily hang between the two cut plumbing pipes.
3
pply plumber's tape or appropriate sealant to the fittings and lines, according to your system configuration.
4
Make all connections and tighten fittings.
NOTE: Keep the Filter System in an upright position.
C UTION
grounding kit (not included) must be installed on water pipes if they are
used to ground electrical systems, appliances or phones.
GROUNDING KIT (NOT INCLUDED)
STEP 6
Install the Filter Housing
1
C
Insert the Filter Cartridge
over standpipe in the bottom of the Filter Housing
2
Screw the Filter Housing back onto the System Head and hand-tighten. Using the Filter Housing Wrench
NOTE: Do not over tighten.
WFCH2 Series
.
D
, tighten 1/4 turn.
5
5
IN
W TER
FLOW
3
6
C
D
OUT
TO
HOUSE
2
V4.0
Publicidad
