Publicidad
Idiomas disponibles
Idiomas disponibles
Caution: Devices may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the rotating holder!
Before rigging make sure that the installation area can hold a minimum point load of 10 times rotating
holders weight.
Follow the instructions mentioned at the bottom of the base.
the structure (truss) to which you are attaching the devices is secure.
Before taking into operation for the first time, the installation has to be approved by an expert!
(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
Use 2 appropriate clamps to rig the device on the truss.
Make sure that the device is fixed properly! Ensure that
DANGER TO LIFE!
CAUTION!
The rotating holder can either be placed directly
on the stage floor or rigged as shown in the
drawing.
For overhead use (mounting height >100 cm),
always install a safety-rope that can hold at
least 12 times the weight of the device. You
must only use safety-ropes with quick links with
screw cap. Pull the safety-rope through the hole
on the bottom of the base and over the trussing
system etc. Insert the end in the quick link and
tighten the fixation screw.
The maximum drop distance must never
exceed 20 cm.
A safety rope which already hold the strain of a
crash or which is defective must not be used
again.
30/83
51837615_V_1_1.DOC
Publicidad
