Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit.
Special adjustment may be necessary to suit local requirement.
Before using your air conditioner, please read this instruction manual carefully and keep it for future reference.
This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay
persons.
This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not play with the appliance.
! WARNING
•
Installation and maintenance should be performed by qualifi ed
persons who are familiar with local code and regulation, and
experienced with this type of appliance.
•
All fi eld wiring must be installed in accordance with the national
wiring regulation.
•
Ensure that the rated voltage of the unit corresponds to that of
the name plate before commencing wiring work according to
the wiring diagram.
•
The unit must be GROUNDED to prevent possible hazard due
to insulation failure.
•
All electrical wiring must not touch the water piping or any
moving parts of the fan motors.
•
Confi rm that the unit has been switched OFF before installing
or servicing the unit.
•
Disconnect from the main power supply before servicing the
air conditioner unit.
•
DO NOT pull out the power cord when the power is ON. This
may cause serious electrical shocks which may result in the
fi re hazards.
•
Keep the indoor and outdoor units, power cable and transmission
wiring, at least 1m from TVs and radios, to prevent distorted
pictures and static. {Depending on the type and source of the
electrical waves, static may be heard even when more than
1m away}.
Disposal requirements
Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall not be mixed with
unsorted household waste.
Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the refrigerant, of oil and of
other parts must be done by a qualifi ed installer in accordance with relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By ensuring this product is
disposed of correctly, you will help to prevent potential negative consequences for the environment and human health. Please contact
the installer or local authority for more information.
Batteries must be removed from the remote controller and disposed of separately in accordance with relevant local and national
legislation.
SAFETY PRECAUTIONS
Please take note of the following important points when
installing.
•
Do not install the unit where leakage of fl ammable gas may
occur.
•
Ensure that drainage piping is connected properly.
•
Do not overcharge the unit.
•
Ensure that the unit's panel is closed after service or
installation.
•
Sharp edges and coil surfaces are potential locations which
may cause injury hazards. Avoid from being in contact with
these places.
•
Before turning off the power supply, set the remote
controller's ON/OFF switch to the "OFF" position to prevent
the nuisance tripping of the unit. If this is not done, the unit's
fans will start turning automatically when power resumes, posing
a hazard to service personnel or the user.
•
Do not install the units at or near doorway.
•
Do not operate any heating apparatus too close to the air
conditioner unit or use in room where mineral oil, oil vapour
or oil steam exist, this may cause plastic part to melt or
deform as a result of excessive heat or chemical reaction.
When the unit is used in kitchen, keep fl our away from going
•
into suction of the unit.
•
This unit is not suitable for factory used where cutting oil
mist or iron powder exist or voltage fl uctuates greatly.
•
Do not install the units at area like hot spring or oil refi nery
plant where sulphide gas exists.
•
Ensure the color of wires of the outdoor unit and the terminal
markings are same to the indoors respectively.
•
IMPORTANT: DO NOT INSTALL OR USE THE AIR
CONDITIONER UNIT IN A LAUNDRY ROOM.
•
Don't use joined and twisted wires for incoming power
supply.
•
The equipment is not intended for use in a potentially
explosive atmosphere.
NOTICE
1-4
! CAUTION
If gas leaks and accumulates around the unit, it may cause
fi re ignition.
If the drainage piping is not connected properly, it may
cause water leakage which will dampen the furniture.
This unit is factory pre-charged.
Overcharge will cause over-current or damage to the
compressor.
Unsecured panels will cause the unit to operate noisily.
Publicidad
