SFS intec IP50-B Manual Del Usuario página 20

Rating plate
IP50-B
2016/44
Built/Serial No.
Made in Switzerland
18 V d.c.
Power Unit
580 min.
SFS intec AG CH-9435 Heerbrugg
4
1 Machine model
2 Year of manufacture
3 Serial no.
4 Technical data accu screwgun
5 CE marking
Safety instructions
Meaning of general safety instructions
The general safety instructions in this section give information about potential residual
hazards that are permanently present despite the tool being used properly or may
occur unexpectedly.
The safety instructions must be observed by all persons who work on or with the tool
to prevent physical injury, damage or harm to the environment. These persons are
therefore obliged to read, understand and observe the provisions of this section.
Meaning of specific safety instructions
For certain situations the applicable safety instructions are given at the relevant place
in the operating instructions. These instructions must be observed in order to prevent
physical injury, damage or harm to the environment.
Statutory requirements
In addition to the safety instructions in this operating manual, the statutory accident
prevention and environmental protection regulations applicable in the country of use
must be observed. Likewise the generally accepted rules for safety and working in a
technically correct manner must be observed.
Consequences of failure to observe the safety instructions
Failure to observe the safety instructions can lead to accidents with resultant physical
injury, damage or harm to the environment. The manufacturer accepts no liability for
injury or damage resulting from failure to observe the safety instructions.
Intended use
The setting tool is intended to be used, in accordance with these operating
instructions, for fastening load distribution plates, in combination with the peel rivet
TPR-L, to critical surfaces. For example to aluminium sheet, thin concrete panels,
fibre cement panels, as well as wooden and plastic panels.
20
1
2 3
5