Axxess AXDI-MB1 Instrucciones De Instalación página 2

(a) From the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness to the
aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the ignition wire.
• Connect the Orange wire to the illumination wire. If the aftermarket radio has
no illumination wire, tape off the Orange wire.
• Connect the Blue wire to the antenna turn on wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
AXDI-MB1
Connections to be made
(b) AXSWC pre-wired harness:
2
The following wires are for the aftermarket radios that have navigation built in:
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio (if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire of the
aftermarket navigation radio (if applicable).
• Connect the Green/Purple wire to the reverse wire of the aftermarket
navigation radio (if applicable).
• This harness is to be used in conjunction with the optional AXSWC (not
included) to retain steering wheel controls. If the AXSWC is not being
used, disregard this harness. If it will be used, please refer to the AXSWC
instructions for radio connections and programming.
Note: Disregard the harness that comes with the AXSWC.