Axxess AXDI-MB1 Instrucciones De Instalación página 3

Installing the AXDI-MB1
With the key in the off position:
• Connect the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness into the interface,
and then to the wiring harness in the vehicle.
AXDI-MB1
Initializing the AXDI-MB1
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
Note: If using the AXSWC, connect it after you initialize the AXDI-MB1, with the
key in the off position.
3