Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
@
Fitting and removing the dust cassette (Fig. G)
Warning! Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.) can
selfignite in sander dust bag or elsewhere and cause
fire. To reduce risk, empty bag frequently and strictly
follow sander manual and coating manufacturer's
instructions.
● The dust bag (4) should be emptied after every 10
minutes of sanding.
● To attach the dust bag to the sander, line up the dust bag
with the dust port (13).
● Slide the dust bag onto the dust port as shown in the
insert of Figure (G).
● To remove, slide the dust bag off.
● To empty the dust bag, remove it from the dust port
and dump the sanding debris into an appropriate trash
receptacle.
Accessories
Warning! Since accessories, other than those offered by
STANLEY FATMAX, have not been tested with this product,
use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only STANLEY FATMAX
recommended accessories should be used with this product.
Maintenance
Your STANLEY FATMAX tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
@
regular cleaning.
WARNING! Before performing any maintenance on
the tool, remove the battery from the tool. Unplug the
charger before cleaning it.
● Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
● Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing demand for raw materials.
Please recycle electrical products and batteries according
to local provisions. Further information is available at
www.2helpU.com
8
(Original instructions)
echnical data
T
Input voltage
V
ac
Oscillations (no load)
min
-1
Orbits (no load)
min
-1
Sanding base surface
mm
2
Weight
kg
Level of sound pressure according to EN 62841:
Sound pressure (Lp
) 77 dB(A), uncertainty (K) 3 dB(A)
A
Sound power (L
) 85 dB(A), uncertainty (K) 3 dB(A)
WA
Vibration total values (triax vector sum) according to EN 62841:
Sanding (ah) 7,7 m/s
%
EC declaration of conformity
MACHINERY DIRECTIVE
SFMEW210 Sander
STANLEY FATMAX declares that these products described
under "technical data" are in compliance with:
EN 62841-1:2015 + AC:2015 +A11:2022 and EN 62841-2-
4:2014 + AC:2015.
These products also comply with Directive 2006/42/EC,
2014/30/EU and 2011/65/EU. For more information, please
contact STANLEY FATMAX at the following address or refer to
the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
STANLEY FATMAX .
Declaration of Conformity
The Supply of Machinery (Safety) Regulations 2008
SFMEW210 Sander
SFMEW210
28000
14000
, uncertainty (K) 1.5 m/s
2
2
Patrick Diepenbach
General Manager, Benelux
Stanley FatMax,
Egide Walschaertsstraat 14-18
2800 Mechelen, Belgium
01/11/2022
230
8866
1.12
Publicidad
