Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
Wheel Capacity .....................................................4-1/2 in.
Rated Speed ........................................... 9,200/min. (RPM)
UNPACKING
This product requires assembly.
Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
INSTALLING/REMOVING WHEEL GUARD
See Figures 1 - 3, page 12.
To install:
Place the guard on the shoulder of the bearing cap by
aligning index arrows on guard and bearing cap. Press
down on guard until it is fully seated.
Depress the lever and rotate guard to the correct position.
Refer to Positioning the Wheel Guard.
NOTE: Be sure the raised ridge on the guard is seated in
the groove on the bearing cap.
Install disc flange, grinding or cutting wheel, and Fixtec
nut as described later in this section.
FEATURES
Spindle Thread ........................................ 5/8 in. x 11 UNC
Wheel.......................Grinding (Type 27) or Cutting (Type 1)
ASSEMBLY
Tighten Fixtec nut securely by hand or with the wrench
provided.
To remove:
Remove the disc flange, grinding or cutting wheel, and
Fixtec nut.
Depress the lever and rotate guard to align index arrows
on guard and bearing cap.
Remove the guard.
INSTALLING/REMOVING GRINDING WHEEL
See Figure 1, page 12.
WARNING:
Thoroughly inspect a new grinding wheel before you
install it on the grinder.
• Tap lightly around the wheel using a wooden hammer.
• Listen carefully to the resulting sounds. Places with
fissures or cracks will result in a different sound.
Do not use a wheel containing fissures or cracks. When
you install a new grinding wheel, carry out a no load
revolution test of approximately one minute with the
grinding wheel facing a safe direction, i.e., away from
people or objects.
Install the wheel guard.
Place the disc flange onto the spindle. Make sure the
flats on the bottom of the disc flange are engaged with
the flats on the spindle.
Place the grinding wheel over the spindle.
WARNING:
Always install a grinding wheel with the depressed center
against the disc flange. Failure to do so will cause the
grinding wheel to crack when tightening the Fixtec nut.
This could result in serious personal injury because of
loose particles breaking off and being thrown from the
grinder. Do not overtighten.
Thread the Fixtec nut on the spindle with the flat side of
the nut facing up.
Fit the raised, small diameter portion of the Fixtec nut
into the hole in the wheel and finger tighten.
7 — English
Publicidad
