SEVERIN HV 7147 Manual De Instrucciones página 26

c
lEaninG anD mainTaininG ThE appliancE
Vacuuming in Power mode
The appliance vacuums at full power in Power mode. The brush roller rotates when the turbo brush is attached.
1. Attach an additional attachment to the appliance if necessary.
2. Push the On/Off switch to the "I" position to switch on the appliance.
The appliance vacuums in Eco mode.
–
The LED on the handle lights up orange.
–
The LEDs on the top of the appliance illuminate the work area.
–
3. Push the On/Off switch to the "II" position to switch the appliance to Power mode.
The appliance vacuums in Power mode.
–
The LED lights up green..
–
TIP: Push the On/off switch back to the "I" position to return to Eco mode.
–
4. Vacuum the surface.
5. Push the On/Off switch to the "0" position to switch off the appliance.
6. Empty and clean the dust container („Cleaning the dust container and filter" auf Seite 26).
TIP: The LED on the handle starts flashing when the battery charge is running low. The appliance
switches off automatically when the battery charge is too low. Charge the rechargeable battery („3
Installing and charging the appliance" auf Seite 24).
4 Cleaning and maintaining the appliance
For additional information on cleaning, see  illustrated Quick Start Guide.
Emptying the dust container
The dust container can only store limited quantities of dirt/water. For this reason, empty the dust container after
each cleaning procedure or if the dust or liquid reach the MAX mark.
2
Cleaning the dust container and filter
26
1. Make sure that the appliance is switched off and is not on charge.
2. Hold the appliance with the suction opening facing down.
3. Press the release catch to disconnect the dust container from the
motor unit.
4. Remove the dust container.
5. Remove the filter and filter holder.
6. Empty the dust container into a waste bin or a drain.