Publicidad
Idiomas disponibles
Idiomas disponibles
"CLEANING"
"TEMPERATURE".
4.2.2- Alarm Messages
In the following cases, the chlorinator shuts down and the alarm and
acoustic alarm LED is activated (automatic reset once the fault is solved):
"NO WATER FLOW"
"SHORT CIRCUIT"
"OPEN CIRCUIT"
"Chlorine Alarm"
Manual PRO250V2 v.1
The chlorinator is in the self-
cleaning process. The process
lasts 5 minutes
The ambient temperature is
>40º
The
radiator
fins
obstructed or are not in a
vertical position.
Excess gas in the electrolysis
cell. It may have occurred
because
the
pump
shutdown.
The
gas
hydrogen gas which is highly
flammable.
Sensor cable of the cell is
incorrectly
connected
broken.
Cell sensor is dirty.
No water flow
The
cell
is
incorrectly
connected.
Metal body in the cell.
Cell is incorrectly connected.
Cell
is
damaged
completely worn down.
Swimming pool water with
very low salt concentration.
Chlorine probe is incorrectly
connected or damaged
None.
Try and place the equipment in
another position where it is not
over
40º
or
ventilation. Leave the equipment to
rest for a few minutes.
Consult section number
4. Installation
are
Place the equipment so that air is
circulated for correct cooling.
The piping should be drained to
eliminate gas or accumulated water.
has
Check the pump.
is
Check the sensor cable (white cable)
or
Clean.
See maintenance.
Check the water system
Check wiring.
Turn off the equipment and remove
the metal body from the plates
Check
the
cell
ensure that cables and connection
terminals are in good condition.
or
Check the condition of the cell
electrodes, and replace it if any
damage is observed.
Ensure that the water has salt and
that it is dissolved.
Check the cabling of the probe and
the probe itself. Check 5.1.
It can work in manual mode if
necessary.
perform
forced
connection
and
44 / 46
Publicidad
