Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 1
For Sliding and Swinging Gates ONLY
Assemble the T-Rail and
Attach the Cable Pulley Bracket
To avoid installation difficulties, do
not run the garage door opener until
instructed to do so.
1. Place the 3 T-rail sections on a flat
surface for assembly. The end sections
are identical. Make sure the "arrow
label" on the center section is pointing
in the direction shown in the
illustration.
2. Connect the center section and the
1/4" lock nuts to the end sections from
the same side, as shown.
NOTE: If T-rail is not assembled exactly as shown,
trolley will not travel smoothly along length of rail
or it will hit against nuts.
3. Insert the carriage bolts from the opposite side of
the end sections. Tighten the nuts. When
assembled, T-rail has a front-to-back position as
shown.
4. Position the cable pulley bracket on the front end
of the T-rail as shown. Fasten securely with the
hardware provided.
NOTE: When tightening the bolts be sure to keep
bracket parallel to the rail. Otherwise, the rail may
bow when the opener is operated.
T-rail
(End Section)
Rail connects to
opener at this end.
Brace
Square Carriage
Bolt Holes
HARDWARE
SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
1/4'' Lock Nut
Brace
T-rail
(Center Section)
Hex Bolts
5/16"-18x7/8"
Tuerca de 1/4"
10
Carriage Bolts
Lock Nut
1/4"-20x1/2"
1/4"-20
Nut
Lock Washer
5/16"-18
5/16"
11 mm Socket Wrench
Cable pulley bracket
attaches to this
end of T-rail.
T-rail
(End Section)
AWAY FROM
OPENER
Carriage Bolt
1/4"-20x1/2"
El sostén de la polea
del cable se fija a este
Cable Pulley
extremo del riel en "T".
Bracket
Lock Washer
Riel en "T"
5/16"
(Sección Extrema)
Nut
5/16"
13 mm Socket Wrench
Publicidad
