Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
U-handle version
Operation shaft assembly
U-handle assembly
Installation of shield
1.
Stand the engine upright on a level surface.
2.
Remove the index bolt (A).
3.
Loosen the clamp bolt (B) at the connection between the en-
gine and the shaft tube.
4.
Carefully fit the shaft tube (C) to the engine, making sure that
the power transmission shaft (D) is correctly engaged.
5.
Rotate the drive shaft housing until the index bolt hole aligns
with the index hole (E) in the shaft tube.
6.
Install the index bolt and tighten both bolts to fasten the drive
shaft assembly.
1.
Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (D) and fix handle by tightening
handle assembling bolt (8 mm) (B) lightly.
2.
Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
C: Washer
E: Arrow
F: To engine
Install the handle so that it does not hide any of the
safety decals.
3.
To eliminate loosening of throttle wire (G) fix it to shaft tube
(H) (2 places) with wire fixing clips (I).
Activate throttle latch and check that throttle valve opens. In-
sufficient opening of throttle valve indicates that throttle wire is
twisted. Rotate U-handle anticlockwise to eliminate the twist-
ing.
1.
Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
10
CAUTION
Publicidad
