Woods SW20FW Manual De Instrucciones página 10

Operating Instructions
GB
CLEANING AND MAINTENANCE
Wood's dehumidifiers require cleaning
and change of filter, to maintain their high
dehumidifying capacity.
- The front grille can be cleaned with a
vacuum cleaner of a soft brush.
- The cooling coils are best cleaned with a
cloth and warm water. Clean with care.
- The fan motor is permanently lubricated
and requires no maintenance.
NOTE: Always disconnect the cord
before cleaning.
HINTS:
- Sometimes it may be useful to use a heater
to make sure that the temperature does not
fall below +2˚C.
- For maximum dehumidifying power in
a room, it is recommended that the air
supply from outside and from adjoining
rooms is minimized – close doors and
ventilators.
- Put the unit in the center of the room
- Increase temp. for faster dehumidification
( warm air carries more water.)
- Use frost guard if temperature falls below
+2°C
- Higher dehumidification in autumn /
summer because outside air is warm and
humid. (Absolute humidity is normally
higher).
WHEN THE DEHUMIDIFIER REQUIRES
SERVICING
If the dehumidifier requires servicing,
you must first contact the retailer. Proof
of purchase is required for all guarantee
claims.
10
GUARANTEES
2 year´s guarantee against manufacturing
faults. Note that the guarantee is only
valid with a proof of purchase (receipt).
NOTE! Get a 6-years warranty!
Register at warranty-woods.com
and replace the SMF-filter at least
once a year. Please visit woods.se for
more information.
Recommended limits for use
Temp. SW +2˚C to +35˚C
Relative humidity: 30% to 90%
Recommended
humidity level: appr. 50% RH
IMPORTANT! - Wood's
dehumidifiers must be connected
to an grounded power source.
The power source sould be
220V-240V 50Hz
06 07