Replace the filter by following below instructions:
1.
Turn off the water supply.
2.
Remove both the white and blue tube from the water filter at the back of the appliance.
3.
Place the new water filter and reconnect the white and blue tube to the filter.
4.
Turn back on the water supply. The water and ice dispenser is now again ready for use.
5.
Reset the water filter function by pressing the filter set (DISPENSER) button for 3
seconds.
ERRORS
· Every time you open the door of the refrigerator or the freezer, you will hear a signal. This
signal only indicates the appliance is operating.
· If the doors are too long open, you will hear an alarm which indicates you need to close the
doors to maintain the temperature inside the refrigerator or the freezer.
· In case of a power cut-off, all settings will be remembered. When the appliance receives
power again, it takes back the preset settings.
Errors on the display
Below error notifications can appear on the display. In that case, it is recommendable to
contact the nearest after sales service for inspection.
Error
E0
E1
E2
Usage Information
E5
E6
Shelving and rack adjustment
E7
EE
Important note: all food and drink should be removed from all shelves
EH
and racks before adjusting or removing them
You can adjust the shelving in the fridge compartment to your required
MOVING THE SHELVES AND DOOR RACK
configuration. To remove a shelf, lift it up slightly so the plastic stabilisers
· Empty the fridge before moving the shelves or the door racks.
that on either side of the shelf are above the shelf rails and then pull it
· To move a shelf, raise it and pull it towards you.
towards you.
60
You can adjust the racks in the fridge and freezer compartments to your
DO933SBS
required configuration. To remove a rack hold both sides of the rack, lift
it upwards (1) and then pull it towards you (2).
Description
Error in the water and ice dispenser.
Problem with the temperature in the refrigerator.
Problem with the temperature in the freezer.
Problem with the automatic defrost sensor.
Error in the communication.
Problem with the ambient temperature sensor.
Problem with the water and ice dispenser sensor.
Problem with the humidity sensor.