Hart HTMS33 Manual Del Operador página 20

OPERATION
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes, resulting
in possible serious injury.
WARNING:
Do not use any attachments or accessories not rec-
ommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
This product has been designed only for the purposes
listed below:
 Cross cutting wood, wood composition and plastic (do
not cut metals, ceramics, or masonry products.)
 Cross cutting miters, joints, etc. for picture frames mold-
ings, door casings, and fine joinery
 Bevel cutting and compound cutting of lumber and mold-
ings
NOTE: The blade provided is fine for most wood cutting
operations, but for fine joinery cuts or cutting plastic, use
one of the accessory blades available from the dealer.
WARNING:
Before starting any cutting operation, clamp or bolt the
compound miter saw to a workbench. Never operate
the miter saw on the floor or in a crouched position.
Failure to heed this warning can result in serious per-
sonal injury.
WARNING:
To avoid serious personal injury, always tighten the
miter lock handle and bevel lock knob securely before
making a cut. Failure to do so could result in movement
of the control arm or miter table while making a cut.
WARNING:
To avoid serious personal injury, keep hands outside
the no hands zone, at least 4 in. from the blade. Never
perform any cutting operation freehand (without holding
workpiece against the fence). The blade could grab the
workpiece if it slips or twists.
NOTICE:
Do not start the compound miter saw without checking
for interference between the blade and the miter fence.
Damage could result to the blade if it strikes the miter
fence during operation of the saw.
CUTTING WITH YOUR COMPOUND MITER
SAW
WARNING:
When using a work clamp or C-clamp to secure your
workpiece, clamp workpiece on one side of the blade
only. The workpiece must remain free on one side of the
blade to prevent the blade from binding in workpiece.
The workpiece binding the blade will cause motor
stalling and kickback. This situation could cause an
accident resulting in possible serious personal injury.
WARNING:
NEVER move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade is
rotating. Any slip can result in contact with the blade
causing serious personal injury.
LED LIGHTING SYSTEM
See Figure 23.
WARNING:
Do not stare into the light beam (not even from a dis-
tance). Staring into the light beam may result in serious
injury or vision loss.
The LED lighting system casts the shadow of the blade onto
the workpiece. This results in greater accuracy of cuts and
requires no adjustments.
To use this feature, turn the LED switch on.
Bring the saw arm down so that the blade is approximately
1/4 in. from the workpiece. The shadow of the blade will be
projected onto the workpiece, indicating where the blade
teeth will make contact as the cut is made.
20 – English