Hart HTMS33 Manual Del Operador página 27

OPERATION
CUTTING WARPED MATERIAL
See Figures 32 - 33.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 32.
If the warped material is positioned the wrong way as shown
in figure 33, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed or
warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 34.
When cutting wide workpieces, such as nominal 2 in. x
6 in., boards should be clamped with a C-clamp as shown
in figure 34.
FIG. 32
RIGHT
FIG. 33
FIG. 34
WIDE
BOARD
27 – English
WRONG