Num'axes PIE1048 Manual De Instrucciones página 31

- Try to set your camera up in an area where no heat sources are in the camera's field
of view.
- In some cases, setting the camera near water will make it take images with no subject
in them. Try aiming the camera over ground.
- Avoid setting the camera up on small trees that are prone to move in strong winds.
Try to set the camera on stable and immovable objects, i.e. large trees.
- Remove any tree branches which are right in front of the camera lens.
- At night, the PIR sensor may detect beyond the range of the infrared flash. Reduce
the detection distance by adjusting the PIR sensor sensitivity.
- Rising sun or sunset can trigger the PIR sensor. The camera must be reoriented.
- If a subject moves quickly, it may move out of the camera's field of view before the
photo has been taken. Move the camera further back or redirect it.
Battery life is shorter than expected
- Battery life will vary with operating temperature and the number of images taken
over time. Typically, the camera will be able to capture several thousand images
before the batteries die.
- Check to make sure you have used new batteries.
- Make sure that the power switch was in the ON position and not in the TEST position.
The camera stops taking images/videos or won't take images/videos
- Make sure the SD card is not full. If the memory card is full, the camera will stop
taking photos/videos. To avoid such problem, check that the "Cycle recording"
feature in activated (ON).
- Check the batteries to make sure that there is enough power left for the camera to
work.
- Make sure the camera power switch is in the "ON" position and not in the "OFF" or
"TEST" position.
- Please format the SD card with the camera before using it (especially if the card has
been used in other devices) or when the camera stops taking images/videos.
- Please make sure that the write-protect switch on the side of the SD card is not in the
LOCK position.
The camera won't power up
- Make sure the batteries are installed correctly (follow polarity indicated in the battery
compartment).
- After moving the switch from OFF to TEST or ON, make sure the switch is in the
correct position to ensure the proper mode.
- Do not move the switch directly from ON to TEST, always move the switch all the way
to OFF first, then back to TEST.
PIE1048 - Indice A – Juillet 2020 31/88