Num'axes PIE1048 Manual De Instrucciones página 33

The PIR sensor indicator light flashes/doesn't flash
- When the camera is in the TEST mode, a red indicator light on the front of the camera
flashes when the PIR sensor detects motion. This is for setup purposes only and will
help you aim the camera.
- During use, the indicator light doesn't flash when the PIR sensor detects motion. This
helps keep the camera discreet.
The camera doesn't retain settings
- Make sure you have been saving the changes to any parameter settings that you
made while in TEST mode, by pressing OK after changing the setting.
Moisture or ants inside the camera
- To ensure humidity or rain is kept out of the camera, secure the DC port rubber plug
firmly in place.
- Ants can be attracted by low level electronic vibrations, and enter through any gaps
between the exterior and interior of the camera. Make sure the DC port rubber plug
is firmly in place.
10. Troubleshooting
Should your product stop working or develop a fault, first read this guide over, and then
check the batteries and replace/recharge them if necessary. Also check that you are using
the product correctly.
If the problem persists, contact your distributor or check out on www.numaxes.com.
You can also contact NUM'AXES at +33.2.38.69.96.27 or export@numaxes.com.
Depending on the extent of the malfunction, you may have to return the product for service
and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the after-sales service will have to invoice you for any repair
costs incurred.
11. Guarantee
NUM'AXES guarantees the product against production defects for two years after purchase.
All postage and packing charges will be the purchaser's sole responsibility.
PIE1048 - Indice A – Juillet 2020 33/88