Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
To set the desired room temperature, after switching
on the unit as described above, use the function key
to increase the temperature and
10
the temperature. The set temperature is shown on the
LED display.
Note
The desired room temperature should be higher than
the current room temperature.
Note
The unit has a 60-second overrun. If the set tempera-
ture is reached or the heater is set to standby mode
by pressing the function key
seconds to cool down the unit. This is shown on the
display as a reverse countdown from 60 - 0.
Set ventilation strength
Press the function keys
change the ventilation intensity.
For this setting, the indication on the LED display
changes for a moment and shows either:
LL = low or HH = high
Set timer
The timer can be used for automatic switch-off as well
as for automatic switch-on.
Activate the timer for switching on when the unit is in
standby mode.
You activate the timer for switching off while the unit
is already in heating mode.
Proceed as follows to set the desired time period for
switching on or off:
1.
Press the timer function key
now shows the hours after which the appli-
9
ance is to switch on or off instead of the °C display.
2.
Press the timer function key
times) to enter the desired number of hours.
Confirmation is not necessary. The display
automatically changes back to the °C display after
your selection.
Note
When the timer is activated, the appliance should
never be left unattended in a freely accessible room.
Switch off the unit
1.
Switch off the unit by setting the main switch
to 0.
1
2.
Unplug the plug
3.
Allow the unit to cool down completely.
22
to decrease
11
, the fan will run for 60
12
and
simultaneously to
10
11
9
. The LED display
13
again (several
13
from the socket.
6
Troubleshooting
Problem
Cause
Unit has no power
supply
Unit without
function
Unit or plug is
defective
The room tempe-
rature is above the
temperature set on
the thermostat
Unit does not
heat
The safety ther-
mostat has been
triggered
Air inlet and outlet
Reduced air flow
not free
Solution
Check socket
Check plug /
insert correctly
Check the house
fuse
Contact custo-
mer service or a
specialist
Increase the
thermostat tem-
perature
Switch off the
appliance and
disconnect the
power plug.
Eliminate the
cause of over-
heating before
restarting the
appliance.
Clean and ob-
serve minimum
distances
Publicidad
