JCM Technologies RBMOT30 Manual De Instrucciones página 19

COD. 3200340_Rev01
TRANSMITTER BATTERY LOW INDICATOR
If the battery of a RADIOBAND transmitter programmed into the receiver becomes low, the receiver will beep 4 times
every 20 seconds. If there is more than one transmitter programmed, each safety edge should be activated to identify,
hearing the 4 beeps, which transmitter has a low battery. If the battery power is low, replace it immediately.
In RBMOT500, you can use the second relay on the receiver as an indicator for low battery, the output will activate when
a transmitter with low battery is detected. Jumper B2/LB must be ON for this operation.
OTHER MOTION FUNCTIONS
MOTION GROUPS
This equipment can work with the group identification of the system FREE. Receivers can be configured with a group
(from 0 to 7) that allows management of up to 28 doors independently.
C=channel
G=group
N.B. Group 0 enables all groups.
GROUP CONFIGURATION
RBMOT30 / RBMOT500
Number of check LED flashes
1
2
3
4
5
Coverage Result of check
Very weak Band failure
Weak
Normal
Good
Very good
19
OK
OK
OK
OK