Publicidad
Idiomas disponibles
Idiomas disponibles
COD. 3200340_Rev01
After the receiver has been totally reset, it will be configured with the group of the first radio-programmed transmitter by
enabling the hands free mode.
On powering the receiver, the led R1 will flash the same number of times as the group number with which it is
configured.
INSTALLATION ADVISES
USE OF THE EQUIPMENT
This equipment is intended to be used for remote control and be installed with a safety edge in automatic doors installations. Their
use is not guaranteed for directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
IMPORTANT ANNEX
Disconnect the power supply before handing the unit.
In compliance with the European Directive low-voltage electrical equipment, we hereby inform users of the following requirements:
· For units which are permanently connected, an easily accessible circuit-breaker device must be built into the wiring system.
· This unit must always be installed in a vertical position and firmly fixed to the structure of the building.
· This unit must only be handled by a specialised installer, by his maintenance staff or by a duly trained operator.
· The instruction manual for this unit must always remain in the possession of the user.
· Terminals of maximum section 3,8mm2 must be used for the power supply connections.
· Use time delayed fuses.
· The two working frequencies does not interfere each other.
JCM TECHNOLOGIES, S.A. hereby declares that the product RBMOT30, RBMOT500 complies with the relevant fundamental
requirements of the RED Directive 2014/53/EU, as well as with the Machine Directive 2006/42/EC whenever its usage is
foreseen; and with the 2011/65/EU RoHS Directive.
CE DECLARATION OF CONFORMITY
See website www.jcm-tech.com/en/declarations
RBMOT30 / RBMOT500
>20 cm
20
Publicidad
